You are not logged in.

#1 2015-11-11 01:33:05

Mr Green
Registered: 2010-11-07
Posts: 6,906

Set up of fstab in older ArchBang versions

While working on new installer noticed that fstab was not created. Genfstab would not append fstab as script is running in a user shell. Not sure why this has not been picked up in the past but my thought is most users are running a single partition, in that case systemd seems to handle root partition and boots normally.

My excuse is that while testing I tend the same single partition and never saw any problems with install or bootloader until now.

New abinstall resolves this issue and should allow users to run multiple partitions such as / and /home without any problem.

Comments, suggestions, donations please feel free to contact me mrgreen(at)archbang(dot)org Artix information


#2 2015-11-11 16:18:00

From: Nijmegen, Holland
Registered: 2010-10-12
Posts: 3,630

Re: Set up of fstab in older ArchBang versions

There have been errors in the past with people setting up a separate home partition; so that is now covered.

Getting your questions answered here at ArchBang Forums
Please! Always give hardware info, if there is a chance that 's relevant: #lspci -vnn
On Arch(bang) and Openbox:


Board footer

Powered by FluxBB